Ahh I see good point Tom, In regards to the SAN vmvic configuration do I need to enable multi-path?
I've done a little homework but cant fully make sense of it..... at the moment I've teamed the four nics so I have two 1gbic going to Switch A and B. Now all of the instructions on here say to use multi-pathing you need to set P2000-1 active adaptors then move the others into unused then for P2000-2 do the same but in reverse order. If I do this and set them to unused am I losing the bandwidth of 2gbs to 1?
Thank you for your help so far!
